Table of Contents
Advertisement
Available languages
Available languages
DANGER: RISK OF BURSTING
Air Tank: On February 26, 2002, the U.S. Consumer Product Safety
Commission published Release # 02-108 concerning air compres-
sor tank safety:
Air compressor receiver tanks do not have an infinite life. Tank life is
dependent upon several factors, some of which include operating
conditions, ambient conditions, proper installations, field modifica-
tions, and the level of maintenance. The exact effect of these fac-
tors on air receiver life is difficult to predict.
If proper maintenance procedures are not followed, internal corro-
sion to the inner wall of the air receiver tank can cause the air tank
to unexpectedly rupture allowing pressurized air to suddenly and
forcefully escape, posing risk of injury to consumers.
Your compressor air tank must be removed from service by the end
of the year shown on your tank warning label.
The following conditions could lead to a weakening of the air tank,
and result in a violent air tank explosion:
WHAT CAN HAPPEN
• Failure to properly drain
condensed water from air tank
causes rust and thinning of the
steel air tank.
• Modifications or attempted
repairs to the air tank.
HOW TO PREVENT IT
• Drain air tank daily or after each
use. If air tank develops a leak,
replace it immediately with
a new air tank or replace the
entire compressor.
• Never drill into, weld or make
any modifications to the air
tank or its attachments. Never
attempt to repair a damaged or
leaking air tank. Replace with a
new air tank.
• Unauthorized modifications to
the safety valve, or any other
components which control air
tank pressure.
Attachments & Accessories:
• Exceeding the pressure rating
of air tools, spray guns, air
operated accessories, tires
and other inflatables can
cause them to explode or
fly apart, and could result in
serious injury.
Tires:
• Over inflation of tires could
result in serious injury and
property damage.
5
• The air tank is designed
to withstand specific
operating pressures. Never
make adjustments or parts
substitutions to alter the factory
set operating pressures.
• Follow the equipment
manufacturers
recommendation and never
exceed the maximum allowable
pressure rating of attachments.
Never use compressor to
inflate small low pressure
objects such as children's toys,
footballs, basketballs, etc.
• Use a tire pressure gauge to
check the tires pressure before
each use and while inflating
tires; see the tire sidewall for
the correct tire pressure.
NOTE: Air tanks, compressors
and similar equipment used to
inflate tires can fill small tires
very rapidly. Adjust pressure
regulator on air supply to no
more than the rating of the
tire pressure. Add air in small
increments and frequently use
the tire gauge to prevent over
inflation.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the DXCMSAC260 and is the answer not in the manual?
Questions and answers
I just purchased a Dewalt dxcmsac260 and whan it shuts off a valve opens and it start releasing the air pressure. it's the same valve that opens when I put the compressor in the off position. what can I do to stop this?
To stop the air pressure release from the valve when the DeWalt DXCMSAC260 shuts off, follow these steps:
1. Inspect for Leaks – Visually check air lines and fittings for any leaks.
2. Check the Safety Valve – Manually operate the safety valve by pulling on the ring. If it continues to leak, replace it.
3. Ensure Proper Shut-Off – Turn the Auto/Off switch to the "Off (O)" position.
4. Verify the Drain Valve – Ensure the drain valve is fully closed.
5. Check for Excessive Air Usage – Reduce air consumption if the compressor is overused.
6. Inspect the Hose – Look for any holes or damage in the hose and replace it if necessary.
7. Clean or Replace the Air Filter – If the intake filter is clogged, clean or replace it.
If the issue persists, contact a DeWalt service center.
This answer is automatically generated