Table of Contents
Advertisement
Available languages
Available languages
WARNING: RISK FROM FLYING OBJECTS
WHAT CAN HAPPEN
• The compressed air stream
can cause soft tissue damage
to exposed skin and can
propel dirt, chips, loose
particles and small objects
at high speed, resulting in
property damage or personal
injury.
HOW TO PREVENT IT
• Always wear certified safety
equipment: ANSI Z87.1 eye
protection (CAN/CSA Z94.3)
with side shields when using
the compressor.
• Never point any nozzle or
sprayer toward any part of
the body or at other people or
animals.
• Always turn the compressor
off and bleed pressure from
the air hose and air tank before
attempting maintenance,
attaching tools or accessories.
WARNING: RISK OF HOT SURFACES
WHAT CAN HAPPEN
• Touching exposed metal such
as the compressor head or
outlet tubes, can result in
serious burns.
6
HOW TO PREVENT IT
• Never touch any exposed
metal parts on compressor
during or immediately after
operation. Compressor will
remain hot for several minutes
after operation
• Do not reach around
protective shrouds or attempt
maintenance until unit has
been allowed to cool.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the DXCMSAC260 and is the answer not in the manual?
Questions and answers
I just purchased a Dewalt dxcmsac260 and whan it shuts off a valve opens and it start releasing the air pressure. it's the same valve that opens when I put the compressor in the off position. what can I do to stop this?
To stop the air pressure release from the valve when the DeWalt DXCMSAC260 shuts off, follow these steps:
1. Inspect for Leaks – Visually check air lines and fittings for any leaks.
2. Check the Safety Valve – Manually operate the safety valve by pulling on the ring. If it continues to leak, replace it.
3. Ensure Proper Shut-Off – Turn the Auto/Off switch to the "Off (O)" position.
4. Verify the Drain Valve – Ensure the drain valve is fully closed.
5. Check for Excessive Air Usage – Reduce air consumption if the compressor is overused.
6. Inspect the Hose – Look for any holes or damage in the hose and replace it if necessary.
7. Clean or Replace the Air Filter – If the intake filter is clogged, clean or replace it.
If the issue persists, contact a DeWalt service center.
This answer is automatically generated