Service And Ad Just Ments; Additional Service; Service Information - DeWalt DXCM602 Instruction Manual

Service and Adjustments
ALL MAINTENANCE AND REPAIR OPERATIONS NOT LISTED
MUST BE PERFORMED BY TRAINED SERVICE TECHNICIAN.
Risk of unsafe operation. Unit cycles automati-
cally when power is on. When servicing, you may be exposed
to voltage sources, compressed air, or moving parts. Before
servicing unit unplug or disconnect electrical supply to the air
compressor, bleed tank of pressure, and allow the air compres-
sor to cool.
To Replace or Clean Check Valve
1. Release all air pressure from air tank. See Draining Air Tank in
the Maintenance section.
2. Set the Auto/Off lever to "Off", unplug the unit, and relieve all
air pressure from the air tank.
3. Using an adjustable wrench loosen outlet tube nut at air tank
and pump. Carefully move outlet tube away from check valve.
4. Using an adjustable wrench loosen pressure relief tube nut at
air tank. Carefully move pressure relief tube away from check
valve.
5. Unscrew the check
valve (turn counter-
clockwise) using a
13/16" open end
wrench. NOTE: the
In open
orientation for
position
reassembly.
nothing is
6. Using a screw-
visible.
driver, carefully
push the valve disc
up and down.
7.
8.
9.
10. Replace the outlet tube and tighten nuts.
11. Perform the Break-in Procedure. See Break-in Procedure in

Additional Service

Disassembly or service of the air compressor beyond what is cov-
ered in this manual is not recommended. If additional service is
required, contact your nearest Authorized Warranty Service Center.
Accessories
Recommended accessories for use with your tool are available for
purchase from your local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, please call
1-888-895-4549 or visit our website www.dewalt.com.
for use with this tool could be hazardous. Use only accessories
rated equal to or higher than the rating of the air compressor.
Screwdriver

Service Information

Please have the following information available for all service calls:
Model Number ____________ Serial Number ___________
Date and Place of Purchase ____________________________
In closed position
disc is visible.
22
NOTE: The valve disc should move freely up and down on
a spring which holds the valve disc in the closed position,
if not, the check valve needs to be cleaned or replaced.
Clean or replace the check valve. A solvent, such as paint or
varnish remover can be used to clean the check valve.
Apply sealant to the check valve threads. Reinstall the check
valve (turn clockwise) to proper orientation.
Replace the pressure release tube. Tighten nuts.
the Operation section.
WARNING: The use of any other accessory not recommended