Table of Contents
Advertisement
Available languages
Available languages
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
these symbols.
DANGER: Indicates an imminently hazardous situation
which, if not avoided, will result in death or serious
injury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or serious
injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
NOTICE: Indicates a practice not related to personal
injury which, if not avoided, may result in property
damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS
OR ANY D
WALT TOOL, CALL US TOLL FREE AT:
e
1-888-895-4549
Important Safety Instructions
Important Safety Instructions
WARNING: Do not operate this unit until you read this
instruction manual for safety, operation and maintenance
instructions.
WARNING: CONTAINS LEAD. May be harmful if eaten or
chewed. May generate dust containing lead. Wash hands after
use. Keep out of reach of children.
WARNING: This product can expose you to chemicals
including lead, which is known to the State of California to
cause cancer and birth defects or other reproductive harm. For
more information go to www.P65Warnings.ca.gov.
3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the DXCMSAC260 and is the answer not in the manual?
Questions and answers
I just purchased a Dewalt dxcmsac260 and whan it shuts off a valve opens and it start releasing the air pressure. it's the same valve that opens when I put the compressor in the off position. what can I do to stop this?
To stop the air pressure release from the valve when the DeWalt DXCMSAC260 shuts off, follow these steps:
1. Inspect for Leaks – Visually check air lines and fittings for any leaks.
2. Check the Safety Valve – Manually operate the safety valve by pulling on the ring. If it continues to leak, replace it.
3. Ensure Proper Shut-Off – Turn the Auto/Off switch to the "Off (O)" position.
4. Verify the Drain Valve – Ensure the drain valve is fully closed.
5. Check for Excessive Air Usage – Reduce air consumption if the compressor is overused.
6. Inspect the Hose – Look for any holes or damage in the hose and replace it if necessary.
7. Clean or Replace the Air Filter – If the intake filter is clogged, clean or replace it.
If the issue persists, contact a DeWalt service center.
This answer is automatically generated