Table of Contents
Advertisement
Available languages
Available languages
CÓDIGO CAUSA POSIBLE
19
Bajo voltaje al motor
Válvula de retención dañada.
20
Bomba tomada
21
Mala ventilación
22
23
Superficies de enfriamiento sucias
Demasiada contrapresión en el tanque
24
25
El compresor está demasiado frío
SOLUCIÓN POSIBLE
Suministre la energía adecuada
Reemplace la válvula de retención. Comuníquese con un centro de servicio
de fábrica D
WALT o con un centro de servicio autorizado D
e
Comuníquese con un centro de servicio de fábrica D
servicio autorizado D
WALT.
e
Vuelva a ubicar el compresor en una zona con aire fresco, seco y bien
circulado, por lo menos a 30 cm (12") de la pared más cercana.
Limpie muy bien todas las superficies de enfriamiento.
Abra la llave de desconpresión al arrancar el motor.
Mueva el compresor a un lugar más cálido.
73
WALT.
e
WALT o con un centro de
e
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the DXCMSAC260 and is the answer not in the manual?
Questions and answers
I just purchased a Dewalt dxcmsac260 and whan it shuts off a valve opens and it start releasing the air pressure. it's the same valve that opens when I put the compressor in the off position. what can I do to stop this?
To stop the air pressure release from the valve when the DeWalt DXCMSAC260 shuts off, follow these steps:
1. Inspect for Leaks – Visually check air lines and fittings for any leaks.
2. Check the Safety Valve – Manually operate the safety valve by pulling on the ring. If it continues to leak, replace it.
3. Ensure Proper Shut-Off – Turn the Auto/Off switch to the "Off (O)" position.
4. Verify the Drain Valve – Ensure the drain valve is fully closed.
5. Check for Excessive Air Usage – Reduce air consumption if the compressor is overused.
6. Inspect the Hose – Look for any holes or damage in the hose and replace it if necessary.
7. Clean or Replace the Air Filter – If the intake filter is clogged, clean or replace it.
If the issue persists, contact a DeWalt service center.
This answer is automatically generated