www.ti.com
3.4 Hardware Configuration
3.4.1 Unused Components
The EVM contains several component patterns which are not used. Components could be populated to divide
the voltage to the J4 output connector or limit the voltage to the signal FETs. Adjustments to installed resistors
may be needed to divide voltages. If using these patterns for evaluation monitor the temperature of the board
and limit current as needed. See the schematic in
SLUUC95A – AUGUST 2020 – REVISED NOVEMBER 2020
Submit Document Feedback
Figure
4-7.
Copyright © 2020 Texas Instruments Incorporated
BQ77216 Circuit Module Use
BQ77216 Evaluation Module
7