Advertisement

Quick Links

WH18DD
Handling instructions
en
zh
使用說明書
ko
Hướng dẫn sử dụng
vi
คู  ม ื อ การใช ง าน
th
Petunjuk pemakaian
id
‫ﺗﻌﻠﯾﻣﺎت اﻟﻣﻌﺎﻟﺟﺔ‬
ar
en
zh
ko
vi
th
id
ar

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WH18DD and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for HIKOKI WH18DD

  • Page 1 WH18DD Handling instructions 使用說明書 Hướng dẫn sử dụng คู  ม ื อ การใช ง าน Petunjuk pemakaian ‫ﺗﻌﻠﯾﻣﺎت اﻟﻣﻌﺎﻟﺟﺔ‬...
  • Page 3 3200 /min...
  • Page 4: General Power Tool Safety Warnings

    English c) Prevent unintentional starting. Ensure the GENERAL POWER TOOL SAFETY switch is in the off -position before connecting WARNINGS to power source and/or battery pack, picking up or carrying the tool. WARNING Carrying power tools with your  nger on the switch Read all safety warnings, instructions, illustrations and or energising power tools that have the switch on speci...
  • Page 5: Additional Safety Warnings

    14. Please use the designated attachments which are temperature range speci ed in the instructions. listed in the operations manual and HiKOKI’s catalog. Charging improperly or at temperatures outside Accidents or injuries could result from not doing so.
  • Page 6: Caution On Lithium-Ion Battery

    English 22. Do not look directly into the light. Such actions could 7. If the battery charging fails to complete even when a result in eye injury. speci ed recharging time has elapsed, immediately stop Wipe off any dirt or grime attached to the lens of the LED further recharging.
  • Page 7: Standard Accessories

    The speci cations of this machine are listed in the Table on No-load speed page 54. /min Oscillation per minute NOTE Due to HiKOKI’s continuing program of research and Impact rate development, the speci cations herein are subject to change without prior notice. Small screw CHARGING Ordinary bolt Before using the power tool, charge the battery as follows.
  • Page 8: Mounting And Operation

    English Table 1 Indications of the pilot lamp Lights for 0.5 seconds. Does not light for Before charging Blinks 0.5 seconds. (off for 0.5 seconds) Lights continuously While charging Lights Lights for 0.5 seconds. Does not light for Charging Blinks 0.5 seconds.
  • Page 9: Maintenance And Inspection

    On 0.3 second/off 0.3 second Temperature Protection Allow the tool and battery to thoroughly cool. MAINTENANCE AND INSPECTION Important notice on the batteries for the HiKOKI cordless power tools 1. Inspecting the driver bit Please always use one of our designated genuine Using a broken bit or one with a worn out tip is dangerous batteries.
  • Page 10: Troubleshooting

    English TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the HiKOKI Authorized Service Center. Symptom Possible cause Remedy Tool doesn’t run No remaining battery power Charge the battery.

Table of Contents