Connect the water drain as follows:
Drain into a sink
■
Drain in a siphon
■
The connection point must be secured
with a hose clip, ∅ 24 - 40 mm
(specialist retailer).
Drain into a plastic pipe with a
■
rubber sleeve or a gully
Set up and connect the device
Electrical connection
:
warning
Risk of electric shock / risk of fire / damage to
property and equipment!
Improper installation of the device is
dangerous. Make sure of the following:
The mains voltage at your socket outlet
■
and the voltage information on the
device (device label) must match. The
connection values and the required
fuse are specified on the rating plate.
The mains plug and the protective
contact socket must match and the
■
earthing system must be installed
correctly.
The installation must have a
■
sufficiently large cable cross-section.
The power plug must be freely
■
accessible at all times. If this is not
possible, a switch (2-pole disconnection)
must be installed in the fixed
installation in order to comply with the
relevant safety regulations in
accordance with the regulations for
electrical installation.
When using a residual current circuit
■
breaker, only one type with the symbol
z can be used. Only this symbol
guarantees compliance with the
current regulations.
Connect the device to the power
supply as follows:
1.
Insert the mains plug of the device into the
socket provided for this purpose.
2.
Check that the power plug is firmly
seated.
Your device is now ready for use.
de
17th