Odor build-up in the device
Program duration changes
during the drying or
washing cycle
Program duration longer
than usual
Drying time too long.
Residual water in the chamber i for
care products
Water not visible in the
drum
Brief jerking / turning of the drum
after the program has started
Loud noises, vibrations or
"wandering" when
spinning
Water is leaking out.
If you cannot rectify a fault yourself (after switching off / on) or a repair is required:
Switch off the device and pull the plug out of the socket.
■
Turn off the tap and call customer service.
■
- - - - - - - -
Run the program Cotton 90 ° C without laundry.
Use powder detergent or a detergent containing bleach
for this.
Note:
To avoid foam formation, only use half the amount of
detergent recommended by the detergent manufacturer. Do
not use wool or mild detergents.
Not a fault - the program sequence is optimized for the respective
washing or drying process. This can lead to a change in the duration of
the program.
No mistake
■
The unbalance control system compensates for the unbalance by distributing the
laundry several times
The foam control system switches on a rinse cycle if the foam builds up
■
too much
Run the program Cotton 90 ° C without laundry. An
■
ambient temperature lower than 30 ° C can extend the
■
drying time.
Insufficient air circulation in the room can increase the drying time.
■
Ventilate the room sufficiently.
Clean the insert ~ Page 46
Note:
The effect of the care product is not impaired.
Not a fault - the water is below the visible range.
When the washing program is started, the drum may jerk
briefly due to the internal motor test.
Make sure, that
the device is correctly aligned ~ Page 18
■
the device feet are fixed ~ Page 18
■
the transport locks have been removed ~ Page 13
■
Make sure the drain hose is properly attached and
■
undamaged.
Check the screw connection of the inlet hose and tighten it if
■
necessary.
Clean and maintain
de
51