Siemens WN44G240 User Manual page 13

You could cut your hands on the sharp
■
edges of the device.
Do not take hold of the device by the
sharp edges and use protective gloves.
■
Incorrect laying of the hose and power
V
risk of injury!
lines creates the risk of tripping and
injury. Lay hoses and cables so that
there is no risk of tripping.
Installation area
Caution!
Equipment damage
Frozen hoses can tear or burst.
Do not set up the device in areas where
there is a risk of frost or outdoors.
Note: Stability is important so that the
device does not wander!
The installation surface must be firm
■
and level.
Soft floors / floor coverings are not
■
suitable.
All four feet of the device must be
■
firmly on the floor.
Set up the device on a base:
Caution!
Equipment damage
The appliance can wander during the spin
cycle and tip / fall from the base. It is
essential to fasten the device feet with
retaining straps. ~ Page 19
Set up the device on a wooden joist
ceiling:
If possible, set up the device in a
■
corner
Place the device on a water-resistant
■
wooden board (min. 30 mm thick) that
is firmly screwed to the floor.
Set up and connect the device
Installing the device in a kitchen unit:
A niche width of 60 cm is required.
Only set up the device under a continuous
worktop that is firmly connected to the
adjacent cabinets.
:
warning
Risk of death!
Contact with live parts creates the risk of
electric shock. Do not remove the device
cover plate.
Transport locks
Caution!
Property and equipment damage
The device is secured with transport locks
for transport. Transport locks that are not
removed can damage the device during
operation. Before using the device for the
first time, it is imperative that you
completely remove all transport locks.
Keep the backups. It is imperative that you
reinstall the fuses before each transport in
order to avoid transport damage.
de
13