Table of Contents
Advertisement
EBL2 Operation
If EBL1 is selected or EBL2 is not displayed, press [EBL1/EBL2] key to select EBL2 before starting
operation.
(The currently selected EBL is highlighted at the lower right of the screen.)
Procedures
1
Press [EBL1/EBL2] key to select EBL2.
EBL2 at the lower right of the screen will be highlighted, and EBL2 becomes operable.
2
Adjust the bearing of EBL2 with [JOG DIAL] or [TRACKBALL].
3
Press [ENTER] key.
The bearing of EBL2 is fixed.
Clearing EBL
Procedures
1
Hold down [EBL1/EBL2] key.
The EBL (current selected EBL) display will disappear.
Or put the cursor on EBL1 / EBL2 and hold down [ENTER] key.
Setting EBL display
Select either true bearing or relative bearing.
Procedures
1
Put the cursor on the button at the lower right as following figure.
Press [ENTER] key.
The bearing mode is switched to true or relative.
3.5 GENERAL OPERATIONS
3-17
3
Advertisement
Table of Contents
Troubleshooting
