Uniden BW6101R Series Owner's Manual page 20

Date and Time
S et the monitor to automatically enter sleep mode according to the length of time
set to increase the monitor standby time. Any of the detection triggered will turn
the LCD back on. If none of the detection is active, press the power button on the
monitor to turn the LCD back on.
1. Press the MENU button on the monitor, and select
2. Select the time length desired for the monitor to enter sleep mode.
3. Press OK to save settings.
Power Save
To extend the battery operating time for the battery powered camera, you may use
this function if the camera solely connected to the monitor.
To view the camera using an app, please ensure the power saving settings for the
camera is turned off. If having issue viewing the camera feed using an app, please
check the camera power saving settings on the monitor or reset the camera and
add it in the Baby Watch Plus app again.
The battery powered camera unit will have the battery level icon indicated on the
home screen of the monitor. Please charge the battery level is low.
Reset
This option allows you to restore your system to factory setting. The monitor will
reboot and all menu settings, WILL be affected by the reset.
1. Press the MENU button on the monitor, and select
2. Press OK to reset the monitor.
3. Press LEFT and RIGHT direction buttons to change options between Yes or No
and then press OK to proceed with the selection.
Device Information
1. View the monitor and camera firmware version.
2. Press the MENU button on the monitor, and select
3. Press LEFT and RIGHT direction buttons to toggle between the monitor and
camera firmware information.
20
> Date and Time.
> Reset.
> Device Information.