Transportation, Storage And Disposal - Husqvarna FS400LV Operator's Manual

6. Examine the oil level on the dipstick. Make sure that
the level of engine oil is between the marks on the
dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
engine oil on page 19 for correct engine oil type.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and faster to drain.
WARNING:
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
WARNING:
your body, clean with soap and water.
CAUTION:
2-stroke engines. Engine oil for 2-stroke
engines can cause damage to the engine.
• Refer to the operator's manual supplied by the
engine manufacturer.
CAUTION:
safe disposal of used engine oil.
To clean and replace the air filter
WARNING:
protection when you clean or replace the air
filter. Discard used air filters correctly. The
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
The wheels let you move the product manually for
shorter distances. For longer distances, lift the product
to move it or put the product on a vehicle.
1852 - 001 - 25.11.2022
To replace the
Do not operate the engine
If you spill engine oil on
Do not use engine oil for
Obey local regulations for
Use approved respiratory

Transportation, storage and disposal

Be careful during
dust in the air filter is dangerous to your
health.
WARNING:
with compressed air. This causes damage to
the air filter and the risk increases that you
breathe the dangerous dust.
CAUTION:
air filter, or the dust will go into the engine
and cause engine damage.
• For information on how to clean and replace the air
filter, refer to the operator's manual for the engine.
To examine the spark plug
Note:
Do not use a spark plug with a
damaged spark plug cap or ignition lead.
A damaged spark plug can cause electrical
shock.
CAUTION:
recommended spark plug type. Incorrect
spark plug type can cause damage to the
product.
• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
• To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the fuel type is correct.
b) Make sure that the air filter is clean.
• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct.
• Replace the spark plug if it is necessary.
• For more information, refer to the operator's manual
for the engine.
CAUTION:
behind a vehicle.
• Safety the product during transportation. Make sure
that it cannot move. Use the lifting eye or the base
plate of the product to attach it.
• Remove the cutting blade before transportation of
the product.
• Remove all tools and wrenches.
• For transportation of the product and fuel, make
sure that there are no leaks or fumes. Sparks or
Do not clean the air filter
Always replace a damaged
Always use the
Do not tow the product
19