Maintenance - Husqvarna FS400LV Operator's Manual

1. Slowly turn the cutting depth wheel counterclockwise
to lower the cutting blade.
2. Make a cut as a guide, approximately 20-30 mm/
0.8-1.2 in.
3. Do cut increments of 50 mm/2 in. until you get
the necessary depth. Push the lever up to lock the
cutting depth wheel.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
16

Maintenance

Read and understand the
4. Adjust the water supply when you operate the
product. Turn the water tap to adjust the water
supply.
CAUTION:
blade must have sufficient supply of
water to cool down the cutting blade.
The water also prevents dust buildup.
5. Cut only in a line, align the cutting blade with the
marks.
6. Slowly push the product forward and make sure that
the pointer and the cutting blade are aligned with the
marks.
CAUTION:
move the product from side to side while
the cutting blade rotates.
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
Each side of the cutting
Do not turn, rotate or
1852 - 001 - 25.11.2022