General Safety Instructions - Nassenheider Fill Up 2 Manual

8

General safety instructions

4 General safety instructions
The safety instructions generally apply to all FILL-Systems products.
Danger of hand injuries
Make sure that during operation of the machine, your hands (as well
as hair, clothing, etc.) do not get caught in rotating parts (gears,
driving shafts) or other moving parts.
In case of dismantling (e.g. when removing the pump head) or
cleaning, turn the power off and unplug from the power supply.
Risk of injury from electrical current
Protect the electronic connections to the power adapter against
moisture. Please ensure that all electrical cables / wires are installed
in such a way they cannot be damaged, crushed or can impair the
insulation.
Never open the driving module, the power adapter or a plug.
In the case of disassembly (e. g. when removing the pump head) or
cleaning, the device must be disconnecte from the mains!
Risk of contamination of the product by damaged wear parts
Carry out a subsequent cleaning and visual inspection of the following
components after each finished filling process (or at least once daily):
1. gears / impeller rotor / hoses of the pump head
2. filling nozzles
3. gaskets
4. seals
5. hoses.
Damaged parts must be replaced immediately.
Special comments
This type of machine is electronically controlled by a microcomputer.
Faults / malfunctions during further operation under the influence of
strong electrical or electromagnetic fields cannot be ruled out
completely even though such events are highly unlikely.
Should this happen, please proceed as follows:
- turn off the machine,
- wait at least 10 seconds,
- restart the machine,
- if necessary perform a factory reset.