Filling Nozzles - Nassenheider Fill Up 2 Manual

22 Putting into operation
7.6

Filling nozzles

Wedge nozzle outside Ø 26 mm, hard (Art. 306015)
(see Fig. 17)
Put directly into the pump head with a the clamping flange.
Application: for highly viscous honey
Conical filling nozzle with support (Art. 306002 and 306005)
(see Fig. 18)
Application: especially for slightly viscous honey and
filling into small jar sizes
Assembly:
- insert conical filling nozzle into the pump head
- put the support onto the filling nozzle
- fix the nozzle with the clamping flange
- fasten the clamping flange with nuts.
Filling nozzle, flat, hard with limitation cross
(Art. 306001 and 306006)
(see Fig. 19)
Application:
- Position 1: When filling with a funnel or direct connection
to a container, the upper gasket in the pump head can be
exchanged for pressure reduction against the flat filling
nozzle.
In the case of very slightly viscous products, this prevents
flow through the pump head and dripping from the filling
nozzle by the pressure from above.
In the case of highly viscous and non-dripping products, the
flat filling nozzle is not necessary as a pressure reducer.
- Position 2: The flat filling nozzle can also be used for filling in
large jars. For this purpose, the limitation cross and the flat
filling nozzle are inserted into the pump head at the bottom
and fixed by means of the clamping flange.
Fig. 17: Wedge nozzle
on pump head
Fig. 18: Conical filling
nozzle on pump head
Fig. 19: Flat filling
nozzle on pumpe head