Table of Contents
Advertisement
Fig. 14: Insert the green/blue,
greased shaft seal
Lubricate the new shaft seals with food
grade grease (e.g. vaseline) and insert
them into the housing
(see Fig. 14 and Fig. 15):
Press the two shaft seals carefully, straight
and completely into the provided drilling
hole.
Fig. 16: Insert the driving shaft
Putting into operation
Fig. 15: Insert the red/blue,
greased shaft seal
First the green/blue shaft seal with the
groove downwards, then the red/blue one
with the groove upwards. The two flat
sides of the shaft seals have to face each
other.
Grease the driving shaft, insert it into the
housing from behind by using the rubber
hammer (see Fig. 16).
Be careful not to damage the shaft seals.
Press the white plastic ring over the ball
bearing, so that it is flush with the
housing (knock if necessary). Then insert
the pair of gears, put the cover gasked
into the specific groove, place the cover
and tighten (hand-tight) all the screws.
21
Advertisement
Table of Contents
