SR 63 Compressed air hood 1. General information 2. Parts • In environments that are Immediately Dangerous to Life and 3. Use Health (IDLH). • With oxygen or oxygen-enriched air. 4. Maintenance 5. Technical specification • If you find that breathing is difficult. 6.
2.2 Accessories / Spare parts • Use the control valve knob to set the air flow rate to suit the work Fig. 1. intensity. Fig. 3. In the fully closed position (turn anti-clockwise), the flow is around 150 l/min, while in the fully open position (turn clockwise), it is around 240 l/min.
• Fit the visor, with the tape facing downwards, over the rubber Compressed air supply tube AS/NZS studs. Bear in mind that the holes for the head harness screws Approved tubes must be used if Australian Standards approval is must be oriented in the same direction as the hood and frame. to be valid.
Page 12
The SR 63 Compressed Air Hood is manufactured within a quality management system accepted by Notified Notified Body 2849: INSPEC International B.V., Beechavenue 54-62, 1119 PW, Schiphol-Rijk, The Netherlands. Sundström Safety AB SE-341 50 Lagan • Sweden Tel: +46 10 484 87 00 info@srsafety.se •...
Need help?
Do you have a question about the SR 63 and is the answer not in the manual?
Questions and answers