Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Sundstrom Manuals
  4. Safety Equipment
  5. SR 63
  6. Operating instructions manual

Sundstrom SR 63 Operating Instructions Manual

Compressed air hood
Hide thumbs Also See for SR 63:

Advertisement

Quick Links

Download this manual
Operating instruction
SR 63
Compressed air hood
Revision: 02
OI03H-0318 SR 63
1
2020-06-04

Advertisement

loading
Need help?

Need help?

Do you have a question about the SR 63 and is the answer not in the manual?

Questions and answers

Related Manuals for Sundstrom SR 63

Summary of Contents for Sundstrom SR 63

  • Page 1 Operating instruction SR 63 Compressed air hood Revision: 02 OI03H-0318 SR 63 2020-06-04...

  • Page 2: General Information

    Sundströms compressed air hood SR 63 is a continuous flow compressed air line breathing apparatus in approved according to EN 14594:2005, 3A/3B. When selecting equipment for SR 63 some of the factors that should be considered are as follows: • Type of pollutant •...

  • Page 3: Breathable Air

    • the air shall have a sufficiently low dew point to avoid internal freezing of the equipment. In the event of uncertainty as to whether the above demands have been met, a filter such as the Sundström type SR 99-1 compressed air filter should be connected. OI03H-0318 SR 63 2020-06-04...
  • Page 4 Unpacking the SR 63 Packing list: • Hood with breathing hose • Control valve • Belt • Flow meter • Protective film • User instructions OI03H-0318 SR 63 2020-06-04...

  • Page 5: Functional Check

    • The float can move freely. go, in order to throttle the air • The air supply is not flow rate to a minimum. restricted by kinks or other restrictions in the hoses. OI03H-0318 SR 63 2020-06-04...
  • Page 6 Unroll the compressed air 150 l/min, while in the fully tube and make sure that it is open position (turn clockwise), not twisted. it is around 240 l/min. Connect the tube to the control valve inlet. OI03H-0318 SR 63 2020-06-04...
  • Page 7 Turn the knob half that engages in one of clockwise to reduce the width the holes in the upper half and anti-clockwise to increase it. OI03H-0318 SR 63 2020-06-04...
  • Page 8 4.2 In emergency situations, 4.4 Pull the locking ring back. the neck strap can be released without releasing the buckle: Grip the neck strap with one hand on each side of the buckle and pull firmly. OI03H-0318 SR 63 2020-06-04...
  • Page 9 5.2 Pull off the 8 rubber studs 5.4 Place the hood over the and remove the frame and frame and insert the 4 studs visor. into the corresponding holes in the hood. OI03H-0318 SR 63 2020-06-04...
  • Page 10 Secure with the studs, oriented into the guide holes possibly using a pair of pliers. in the visor. OI03H-0318 SR 63 2020-06-04...
  • Page 11 6.2 Release the hose from 6.4 By pulling the hose, check the hood by cutting off the that it is firmly secured to the hose clip with a pair of hood. nippers OI03H-0318 SR 63 2020-06-04...
  • Page 12 Then wash with dishwashing detergent solution, rinse and leave to dishwashing detergent or the dry. like. Rinse and leave to dry. After cleaning, store the equipment in a dry and clean area at room temperature. Avoid direct sunlight. OI03H-0318 SR 63 2020-06-04...

  • Page 13: Maintenance Schedule

    The schedule shows the recommended minimum maintenance Before use After use Annually procedures required in order to ensure that the equipment is always • • • Visual inspection in functional condition. • • Functional check Cleaning • Change of breathing hose • OI03H-0318 SR 63 2020-06-04...