Operation; Switching On And Off; Timer; Charge Level Indicator - Parkside PRPA 20-Li A1 Translation Of The Original Instructions

4. To remove the battery (21) from the
device, press the release button (22)
on the battery and pull the battery (21)
out.
5. Close the battery cover (26) of the con-
trol unit (8) again.
6. Press the bracket (1) down.

Operation

The minimum water level on initial
start-up must be 90 mm.

Switching on and off

Switching the pump on
1. If necessary, insert the battery (21)
into the control unit (8) (see "Inserting/
removing the battery").
2. Press the Power button (4). The charge
level indicator (3) lights up and the
pump starts sucking in water.
Switching the pump off
3. Press the Power button (4). The pump
switches off.
4. Remove the battery (21) from the con-
trol unit (8) (see "Inserting/removing
the battery").

Timer

• With the pump (11) running, press the
button (6).
The LEDs for the timer (7) light up.
Press 1 time -> 5 min use time
Press 2 times -> 10 min use time
Press 3 times -> 15 min use time
As soon as the set use time has
elapsed, the pump switches off auto-
matically.
• Press the button (6) repeatedly until the
LEDs for the timer (7) go out to cancel
the timer prematurely.
Monitor the device during opera-
tion to detect automatic shutdown
or dry running of the pump in good
time and to avoid damage.

Charge level indicator

The charge level of the battery is indicated
by illumination of the corresponding LED
lights on the battery charge level indicator
(3) during operation.
Green LED lights up: Battery >60%
charged
Yellow LED lights up: Battery 60% - 30%
charged
Red LED lights up: Battery 30% - 10%
charged
Red LED fl ashes: Battery <10% charged;
battery needs charging

Charging the battery

If warm, allow the battery to cool be-
fore charging.
Charge the battery (21) when only
the red LED of the charge level indi-
cator on the device or battery is still lit.
1. If necessary, remove the battery (21)
from the device.
2. Slide the battery (21) into the charging
slot of the charger (23).
3. Plug the charger (23) into a power out-
let.
4. Once charging is complete, disconnect
the charger (23) from the mains supply.
5. Pull the battery (21) out of the charger
(23).
IE NI
11