Machine Parameters - Bosch SVE2510 QR Instruction Manual

7 Maintenance
7.17

Machine parameters

In (level 3) S−4a−7, there are machine parameters, a number of which have been described in
the previous sections. Missing information, see options from 6.21 onwards.
In (level 3) S−4b, a set−up is possible, in which the operations are shown step by step for each
setting, see next section.
SETTINGS REMARKS
Tension arm See 7.9.8.
Service Machine information: provide this information to the manufacturer when a
failure cannot be repaired.
Software configuration: information for Bosch personnel.
Monitor the status of the digital inputs and outputs: see e.g. X−13 on the
left−hand page. The 8 digits at the top left correspond with the inputs (X−13)
1A in the electrical diagrams; the 8 digits at the top right correspond with the
inputs (X−13) 1B in the electrical diagrams etc. A "1" means that the function
is active.
Jaws housing service: see 7.15.7 and 7.16.6.
Initialise servo: see 7.9.10, 7.15.6 or 7.16.5 and 8.2.
Times Duration of dosing demand.
Pre−warning end of film reel: the number of minutes that the operator
warning preceeds the end of the film reel. The calculation depends on the
film thickness and the outside diameter of the film−reel core, see 4.4.11.
Various switching on and off delays of the various motors to give the
drives/motors/controls the opportunity to start up and switch off, e.g.:
−Open/close draw−off belts, see 7.9.3.
−Vacuum pump settings, see 7.8.2.
−Servo switching delays, see 7.9.10, 7.15.6 of 7.16.5 en 8.2.
−Duration help window: this duration must be set sufficiently long to be able
to read the information window (1) in an entry field.
−Corner seal jaws (option), see 6.5.5.
Counters
PAGE 73
continued on next page
Bosch Verpackungstechnik
T7.17−E15 − en