Remove And Replace Cross--Seam Jaws; Cross--Seam Jaws, Replacement And Alignment - Bosch SVE2510 QR Instruction Manual

7 Maintenance
7.13 Cross−seam of heat seal (HS)
7.13.3 Remove and replace cross−seam jaws
Risk of damage!
While mounting the higher jaws, the cross−seam jaws may hit parts of the forming
set. The highest allowed position of the cross−seam jaw housing must be
corrected, see 4.4.13 and/or 6.7.1.
METHOD
If necessary, disassemble options for removal.
Remove knife, see previous page.
Remove the screws (16). Attention: the jaw may fall.
Remove knife jaw (1), together with isolating block(s) (9).
Remove the counterjaw (10) in the same way.
Place in reverse order.
Mount options (if present).
7.13.4 Cross−seam jaws, replacement and alignment
METHOD
Remove options, jaws and knife, see above.
Mount the jaws on the carrier (8 and 12), but do not tighten the screws
(13, 14, 16 and 17).
Fit the knife (6) in the reverse order.
Set the knife jaw (1) horizontally. The knife must be easily moveable.
Tighten screws (16 and 17).
Close the cross−seam jaws.
Accurately align the knurls (15) horizontally and vertically and tighten
the screws (13 and 14).
Set the sealing pressure and check the position of the first jaw carrier.
Open the jaws, see 6.20.3.
Mount options (if present).
Check and correct the highest allowed position of the cross−seam
jaws if the jaws are mounted at another height.
PAGE 39
NOTES
Depends on the model.
Dowel pins (11)
determine the position.
NOTES
With model A with 4
isolating blocks (9), the
extra blocks do not
need to be adjusted.
See 6.20.3.
See 6.20.2.
See 6.7.1.
Bosch Verpackungstechnik
T7.13.3−E33 − en