Bosch SVE2510 QR Instruction Manual page 181

6 Change of size/product
6.8 Change forming set (continued)
Danger of burns!
The long−seam jaw(s) and the cross−seam jaws can be hot just after machine
operation. Do not touch parts that are at operating temperature. Wear protective
gloves when handling such parts. When the long−seam arm has been opened, pay
special attention to the left−hand side of the hot long−seam jaw(s).
Danger of injury and damage!
Do not stand on the cross−seam jaw housing.
Two persons are needed when the forming set with options is heavy.
A plastic shoulder breaks easily.
OPERATION METHOD
Slide the format Open guides (14) (option), if present.
set forwards Slide the format set forwards until the shoulder
plate (4) is just free from the clamping device.
Lift the forming set Support the forming set with one hand at the
manually out of bottom of the forming tube and take the grip (3)
the machine with the other hand.
Lift the forming set out of the machine and store it
or carefully.
Lift the forming set Attach a strap to the grip (3) and lifting device.
with a lifting device Lift the forming set out of the machine with the
out of the machine lifting device and store it carefully.
Prepare film, Cut the end of the film web tongue−shaped.
forming set and Select the required new forming set and, if
options necessary, auger and options.
Check whether these are clean and in a good
condition.
If necessary, mount the auger and/or options in the
forming tube.
PAGE 27
REMARKS
Pay attention to the
limit ranges for lifting
and carrying weights
(loads).
Do not lay the Do not lay the
shoulder on the floor
because of the risk of
damage!
If necessary, see 6.9.
continued on next page
Bosch Verpackungstechnik
T6.8b−E15 − en