Nakanishi CTS-2630 Operation Manual page 18

< Using the mounting holes (front) >
（1） Insert the spindle body housing (diameter φ26 mm) section into the fixed base of the machine tool.
（2） Secure the spindle through the mounting holes (2 locations) using the fastening bolts (M6). (Fig. 18)
< Using the mounting holes (rear) >
（1） Insert the spindle body housing (diameter φ26 mm) section into the fixed base of the machine tool.
（2） Secure the spindle through the mounting holes (2 locations) using the fastening bolts (M6). (Fig. 19)
< When using the mounting holes (side) >
（1） IInstalling from the spindle side
Secure the spindle through the mounting holes (3 locations) using the fastening bolts (M5). (Fig. 20)
（2） Installing from the mounting plate side
Secure the spindle through the mounting holes (3 locations) on the mounting plate side, using the
fastening bolts (M6). (Fig. 21)
Fastening bolt (M6)
Fastening bolt (M6)
Fig. 18
Fig. 20
Fastening bolt (M5)
Fastening bolt (M5)
Fastening bolt (M6)
Fastening bolt (M6)
Fig. 19
Fastening bolt (M6)
Fastening bolt (M6)
Fig. 21
37