Drive Bay Installation/Removal - Fujitsu HX2560 M1 User Manual

HX2560 M1/HX2560 M2 User's Manual
6-5

Drive Bay Installation/Removal

The hard drives are mounted in drive carriers to simplify their installation and removal
from the chassis. These carriers also help promote proper airflow for the drive bays. For
this reason, even empty carriers without drives installed must remain in the chassis.
Removing Hard Drive Carriers from the Chassis
1. Press the release button on the drive carrier. This extends the drive carrier handle.
2. Use the handle to pull the drive carrier out of the chassis.
Installing Hard Drive Carriers to the Chassis
1. Insert the hard drive and drive carrier into its bay vertically, keeping the carrier
oriented so that the release button is on the bottom. When the carrier reaches the
rear of the drive bay, the handle will retract.
2. Using your thumb, push against the upper part of the hard drive handle. Push the
hard drive into the hard drive bay as illustrated below, until the hard drive clicks
into the locked position.
Figure 6-5. Proper Installation of the Carrier into the Hard Drive Bay
Figure 6-4. Removing a Hard Drive Carrier
6-4