With Wireless Remote Control Switch; Filter Cleaning; Taking Out The Filter; Clean The Filter - Hitachi RPK1.5FSNK1 Operation Manual

< PC-LH3C >
Perform the following steps to change the identification
setting of Indoor Units Installed Side by Side setting

with Wireless Remote Control Switch :

1
Open the battery cover of Handset.
Find the identifier switch in location as shown in
2
the figure.
3 Use a pen point shift position of switch from A
to B as shown
PRESS
PUSH
Grip and Push in the
direction of arrow

12. Filter Cleaning

12.1 Taking Out the Filter

(Hiwall - FSNK2 & RPI models)
When Using PC-AR / PC-ARF
When Using PC-LH3B/3C/PC-AWR
The indication of the filter in front of the unit is
turned ON after approximately 200 hours of
operation.
14
in the figure.
IDENTIFIER
SWITCH LOCATION
A
< In Case of 0.8 HP to 2.5 HP Hi-wall units >
Refer to Installation & Maintenance manual for
detailed steps to clean the filter.
< In Case of 1.0 to 3 HP In-the ceiling units >
Take the filter out from suction side of indoor unit by
lifting the filter upwards as shown in below figure:
B
Take the filter out from suction side of indoor unit by
lifting the filter clamp as shown in below figure:

12.2 Clean the Filter

12.3 Reset of Filter Indication

button (in off mode). The FILTER indication will
disappear and next filter cleaning time will be set.