DAXYS Bandicoot User Manual page 7

Perform test
1. Locate the power button on the right side of the handlebar and press it for 3 seconds to power on the scooter. You
should now be able to see the display powered on. Keep the scooter elevated on the stool or bench, as the testing will
involve spinning both wheels.
The scooter should be in Kick to Start mode, to begin testing the motors, spin the rear wheel and then press the
throttle. The wheels should begin to spin normally. You may notice motor emitting a noise at low speeds, this is normal.
The motor is communicating with the controller and identifying its position as well as which direction to roll in. If after
performing this test the wheels are spinning normally, you can now move to step 2.
*If you notice one of the motors is not spinning PLEASE DO NOT ATTEMPT TO OPERATE THE SCOOTER. Contact us immediately.
2. Begin by testing your brakes. Press the throttle on the right side of your handlebar and notice rear wheels start to
accelerate and spin the front wheel with your hand. Continue to accelerate for 5 seconds, then release the throttle and
slam both brakes at the same time. The wheel should stop immediately.
3.Test gear change by pressing the Power Button. A short click will change the speed levels.
・ 1 click – Eco mode
・ 2 clicks – Dynamic mode – after a second click you should see a Green "S" on the display.
・ 3 clicks – Sport mode – another short click should display a Red "S".
*To read more about the speed of each mode, refer to the Diplay section in this manual.
4. Next, to turn on the lights press the Light button. Confirm all of the lights power on: headlight and one rear tail light.
*If all of the lights do not power on, DO NOT ATTEMPT TO OPERATE THE SCOOTER. Contact us immediately.
1 2 3 4
5