DAXYS Bandicoot User Manual page 22

Failure displays / Error Codes
If a malfunction occurs while using your
display codes will appear on the screen:
F1
E1
BRAKE ERROR
F1 is reported when the
power-on self-test fails.
E1 is reported when the error
occurs during
operation.
Error Code:
If E1/F1 is reported, the brake
handle or it's connectio could
be faulty.
Solution 1:
Check whether the brake
handle wire is connected
properly.
Solution 2:
Replace brake handle to test, if
the error code goes away the
handle was the issue.
Solution 3:
Replace the handlebar assem-
bly to test, if the error code
goes away the display was the
issue.
E2 F2
THE THROTTLE ERROR
F2 is reported when the
power-on self-test fails.
E2 is reported when the error
occurs during operation.
Error Code:
If E2/F2 is reported, the throttle
or it's connection could be
faulty.
Solution 1:
Check whether the throttle wire
is connected properly and the
throttle isn't out of position.
Solution 2:
Replace the throttle to test, if
the error code goes away the
throttle was the issue.
Solution 3:
Replace the handlebar assem-
bly to test, if the error code
goes away the display was the
issue.
20
then one of the following failure
E3
COMMUNICATION ERROR
E3 will show the error in power
system running.
Solution 1:
Check if the connection
between the handlebar
assembly and the communica-
tion cable in the stem is good.
Solution 2:
Replace handlebars to test, If
the error code goes away the
handlebars were the issue.
Solution 3:
Replace the controller to test, if
the error code goes away the
contoller was the issue.