Advertisement
After unpacking, disassemble unit before using the first time. Refer to
"To Disassemble Your Juice Extractor" for directions.
Wash all parts except Motor Base in hot, soapy water. Rinse and dry
immediately. Do not put any part in automatic dishwasher. DO NOT
IMMERSE MOTOR BASE IN WATER.
TO ASSEMBLE YOUR JUICE EXTRACTOR
NOTE:
Be sure motor base is unplugged before assembling parts.
1. Place the Juice Bowl over the Drive Shaft as shown in figure 1. The
Juice Spout should be on the left side of the Motor Base.
2. Insert Basket (figure 2) and rotate slightly until it is seated. Continue
rotating Basket one full turn to make certain it rotates smoothly
without touching anything.
3. Place Cover in position. Fasten Cover Latches by placing top of latch
into groove and snapping down into place (figure 3).
4. Slide Pulp Container onto Motor Base and snap into position (figure 4).
Advertisement
