Troubleshooting - JVC GR-DLS1 Instructions Manual

72
EN
If, after following the steps in the chart below, the problem still exists, please consult your nearest J VC
dealer.
SYM PTOM
1. No power is supplied.
2. " SET DATE/TIME!"
appears.
3. Recording cannot be
performed.
4. There is no playback
picture.
5. Some functions are not
available using the M EN U
button.
6. Some functions are not
available using the Select
Dial.
7. The focus does not adjust
automatically.
8. The cassette won't load
properly.
9. Play, Rewind and
Fast-Forward functions
don't work.
Downloaded from:
1. • The power is not connected
properly.
• The battery is dead.
• The LCD monitor is not
open fully or the viewfinder
is not pulled out when
recording.
2. • The built-in rechargeable
clock lithum battery is
discharged and the
previously set date/time is
erased.
3. • The tape's record safety tab
is set to " SAVE" .
• The Power Dial is set to
" PLAY" .
• " TAPE END" appears.
• The cassette's cover is open.
4. • The camcorder is not getting
power, or some other
malfunction exists.
5. • The Power Dial is set to " " .
6. • The Power Dial is set to
" " , " 5S" and "
7. • Focus is set to " MANUAL" .
• The recording was done in a
dark place, or the contrast
was low.
• The lens is dirty or covered
with condensation.
8. • The cassette is in the wrong
position.
• The battery's charge is low.
9. • The Power Dial is not set to
" PLAY" .
https://www.usersmanualguide.com/
POSSIBLE CAUSES
" .

TROUBLESHOOTING

CORRECTIVE ACTION
1. • Connect the AC Adapter
securely (
• Replace the dead battery
with a fully charged one
( pg. 11).
• Open the LCD monitor
fully or pull out the
viewfinder. The LCD
monitor turns on/off when it
is opened/closed at approx.
90° while the Power Dial is
set to any position except
" OFF" if the viewfinder is
not fully pulled out.
2. • Connect the camcorder to
an AC outlet using the AC
Power Adapter/Charger etc.
for over 24 hours to charge
the clock lithum battery
( pg. 13).
3. • Set the tape's record safety
tab to " REC" (
• Set the Power Dial to " " ,
" " , " 5S" or "
( pg. 19).
• Replace with new cassette
( pg. 14).
• Close the cassette's cover.
4. • Turn the camcorder's power
off and on again (
5. • Set the Power Dial to any
position except " "
( pg. 19).
6. • Set the Power Dial to any
position except " " , " 5S"
and " " (
7. • Set Focus to " AUTO"
( pg. 47).
• Clean the lens and check
the focus again (
8. • Set it in the right position
( pg. 14).
• Install a fully charged
battery ( pg. 10).
9. • Set the Power Dial to
" PLAY" (
pg. 12).
pg. 12).
"
pg. 21).
pg. 19).
pg. 77).
pg. 52).