Audio Dubbing - JVC GR-DLS1 Instructions Manual

70
EN

Audio Dubbing

The audio track can be customized only when recorded on the 32 kHz mode (
N O TES:
● Audio Dubbing is not possible on a tape recorded at 48 kHz, on a tape recorded in the LP mode or on a
blank portion of a tape.
● To perform Audio Dubbing while watching in the television, make connections (
Audio D ub Standby
FIN D EDIT-IN PO IN T
1
Play back the tape to locate the point where
editing will start, then press PAU SE .
EN GAGE AUDIO DUB STAN DBY
2
While holding A. D U B on the remote control,
press PAU SE . " 6e " appears.
N O TES:
● Audio dubbing is possible using an optional microphone connected to the external microphone input
connector (MIC).
● While an optional microphone is connected, the built-in microphone is disabled.
● When editing onto a tape that was recorded at 32 kHz, the old and new soundtracks are recorded separately.
● To select the desired sound for playback, press
● If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded
areas.
● If feedback or howling occurs during TV Playback, move the camcorder's microphone away from the TV,
or turn down the TV's volume.
● Sound is not heard from the speaker during Audio Dubbing. To hear sound, connect optional headphones
to the AV OUT (headphones) connector.
● If you change from 32 kHz to 48 kHz in mid-recording and then use the tape for Audio Dubbing, it is not
effective from the point where 48 kHz recording began.
● During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded at 48 kHz
or a blank portion, Audio Dubbing stops and " ERROR! REFER MANUAL" appears.
RECO RD IN G SO U N D
32 kHz
Downloaded from:
6e
Power D ial
AV O U T
(headphones)
connector
D ISPLAY
FULL SOUND
SOUND 2
SOUND 1
https://www.usersmanualguide.com/
Speaker
RM -V711U
(provided)
BEGIN DUBBIN G
3
Press PLAY , then begin " narrating" .
• Speak into the microphone.
4 PAUSE DURIN G DUBBIN G
Press PAU SE .
5 STO P DUBBIN G
Press STO P .
AU D IO M O N ITO R on the remote control.
O U TPU T SO U N D
Original and new tracks are combined and output in stereo.
New track is output on both " L" and " R" channels in stereo.
Original track is output on both " L" and " R" channels in stereo.
EDITING
pg. 37).
pg. 58).
Remote sensor
External microphone
input connector
(Located beneath
the cover.)
Stereo microphone
D ISPLAY
T W
AU D IO M O N ITO R
A.D U B
PLAY
PAU SE
STO P
(Cont.)