Loading/ Unloading A Cassette - JVC GR-DLS1 Instructions Manual

14
EN

Loading/ Unloading A Cassette

The camcorder needs to be powered up to load or eject a cassette.
PU SH -O PEN
button
O PEN LCD M O N ITO R
1
Press the PU SH -O PEN button and open the
LCD monitor up to an angle of 90 degrees.
2 O PEN CASSETTE CO VER
Turn on the power, then slide the O PEN / EJECT
switch in the direction of the arrow. The
cassette cover releases. Open the cover in the
direction of the arrow until it locks. The holder
opens automatically.
• Do not touch internal components.
3 IN SERT/ REM O VE TAPE
Insert or remove a tape and press " PUSH
HERE" to close the cassette holder.
• Once the cassette holder is closed, it recedes
automatically. Wait until it recedes
completely before closing the cassette cover.
• When the battery's charge is low, you may
not be able to close the cover. Do not apply
force. Replace the battery with a fully
charged one before continuing.
Recording time
TAPE
DVM-30 Approx. 30 min.
DVM-60 Approx. 60 min.
Downloaded from:
Cassette cover
Recording mode
SP LP
Approx. 45 min.
Approx. 90 min.
https://www.usersmanualguide.com/
GETTING STARTED
Cassette holder
PU SH H ERE
N O TES:
● It takes a few seconds for the cassette holder to
open. Do not apply force.
● If you wait a few seconds and the cassette holder
does not open, close the cassette cover and try
again.
● Be careful not to get your fingers caught in the
holder when it's closing. If this happens, the
holder will open automatically after a few
seconds.
● When the camcorder is suddenly moved from a
cold place to a warm environment, wait a short
time before opening the cover.
● Closing the cassette cover before the cassette
holder comes out may cause damage to the
camcorder.
● When shooting again after already shooting a
scene, a blank portion is recorded on the tape or
a previously recorded scene is erased (recorded
over) if you open the cassette cover, regardless of
whether the cassette holder comes out or not. See
page 22 for information about recording from the
middle of a tape.
** To protect valuable recordings . . .
.... slide the erase protection switch on the back of
the tape in the direction of " SAVE" . This prevents
this tape from being recorded over. If you decide
later that you do want to record on this tape, slide
the switch back to " REC" before loading the tape.
(Cont.)
O PEN / EJECT
switch
Erase protection switch**
M ake sure the window
side is facing out.