JVC GR-DLS1 Instructions Manual page 22

22
EN
Recording From The M iddle Of A Tape
When removing a tape on which you were recording, or when you resume recording on a tape after playing
back the recording previously made (without taking the tape out between recordings), perform this proce-
dure.
Stop button
Play/ Pause button
1 SELECT O PERATIO N M O DE
Turn the Power Dial to " PLAY" while pressing
down the lock button located on the dial.
• The power lamp comes on.
PULL O UT VIEW FIN DER O R O PEN
2
LCD M O N ITO R
Pull out the viewfinder fully or open the LCD
monitor to approx. 90° degrees.
3 START SEARCH
Press 4 / 6 , then press 2 or 3 . Watch in the
viewfinder or the LCD monitor for the spot
where you want to begin recording.
4 EN GAGE STILL M O DE
Once you find the spot at which you want to
start recording, press 4 / 6 twice to engage the
Still mode.
Downloaded from:
Rewind button
Fast-forward button
Lock button
Power lamp
Power D ial
https://www.usersmanualguide.com/
RECORDING
5 START RECO RDIN G
Turn the Power Dial to any operation mode
except " PLAY" and " OFF" , then press START/
STOP .
• Start recording from a point prior to the end
of the last recording. A few seconds of the
end of the last recording will be erased.
N O TE:
If you start recording from the end of the previous
recording leaving no blank space, there may be
situations where a clean transition is not possible.
Basic Recording (Cont.)
START/ STO P
button