Dough Hooks - Oster 2384 User Manual With Recipes

dough hooks

Dough Hooks
Attaching the Dough Hooks
Set the speed dial in the OFF position and
unplug the electric cord from the electrical
outlet.
Lift mixer head up and back to tilt it out of
the way of the bowl, while holding it in an
upright position.
Note: The dough hooks must go into the
correct sockets. The mixer will operate with
the dough hooks in the wrong position.
However, you will not get proper kneading
action and you could risk ruining a recipe or
damaging your mixer. Read the following
instructions carefully.
The dough hook with the small washer and
foot goes into the socket on the side of the
mixer nearest the side of the bowl. The other
dough hook with the large washer goes into
the socket nearest the center of the bowl. See
the dough hook symbols located on the
bottom of the mixer head.
Beater-Bowl Drive Adjustment
Automatic bowl rotation is factory set.
Occasionally, a simple adjustment may be
L N
necessary when the bowl fails to rotate.
OCKING UT
To make this adjustment, tilt the mixer head
back. Hold the mixer head in an upright
position and locate the adjustment screw on
the underside of the mixer head. Loosen the
locking nut and turn the adjustment screw on
the underside of the mixer head. Loosen the
locking nut and turn the adjustment screw
clockwise, to lower the mixer head; or counter
clockwise, to raise the mixer head. Retighten
A S
DJUSTMENT CREW
the locking nut. The beater with the nylon
button should lightly touch the bottom of the
mixing bowl.
7