Getting Started; Batteries; Ac Adapter (Main Unit); Change Settings - Oregon Scientific RMR616HGA User Manual

GETTING STARTED

BATTERIES

Batteries are not supplied with this product. You will need
to purchase 2 x UM-3 (AA) 1.5V alkaline batteries for
the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries
for the remote sensor.
Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
Do not use rechargeable batteries.
NOTE
shows when batteries are low.
UNIT
Main
Remote
RMR616HGA lab test R2
LOCATION
Temperature Area when
the INDOOR
temperature is shown.
Temperature Area when
the OUTDOOR
temperature is shown.
6

CHANGE SETTINGS

1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press UP or DOWN to change settings.
3. Press MODE to confirm.

REMOTE SENSOR (THGR122NX)

This product is shipped with a THGR122NX Thermo/
Hygro Sensor that collects Temperature and Humidity
data. Data can be collected from up to 3 sensors.
Additional sensors sold separately.

SETUP SENSOR

Open the remote sensor battery compartment with a
small Phillips screwdriver.
6
1/17/04, 5:03 PM