Motherboard Standoffs; Distribution Plate Installation; Power Supply Securing - SINGULARITY COMPUTERS PowerBoard EVGA E1 Assembly Manual

EVGA E1 PowerBoard Manual
Motherboard standoffs are 9x #6-32 x 10mm SO-F and use 7x/8x #6-32 x 0.25" to secure
them from the back, depending on the PSU support bracket's position:
Motherboards are secured with 9x #6-32 x 0.25".
The Distribution plate uses 6x M4 x 8mm, 4x at the bottom and 2x at the side:
Installing the assembly back into the case is easier
without the distribution plate, it can be slid into
position from the bottom of the case and then
secured to the PowerBoard.
Mind the ARGB LEDs on the PowerBoard while moving
the distribution plate to avoid damaging
them.
The power supply is secured with 4x #6-32 x 0.25".
The 4 corner pieces use rubber spacers on both sides
to protect the PCB:
V0.1 Page | 2