Syst E M Se T Up M Ode; Speed Sensor Calibration - TeeJet 814 Programming And Operating Manual

Syst e m Se t up M ode

The System Setup Mode contains the programming steps that customize the monitor to the
sprayer or sprayer components. These include calibration steps and parameters that, once
programmed, will likely never change. An overview of all programming steps is shown in
"Appendix B: Overview of Programming Steps".
To enter the System Setup Mode:
*
First be sure that the Console is ON (if not put it on by pressing the Pro key and wait until
the normal display is visible).
*
Check if the Master switch is OFF
*
Then press and hold the Pro key to enter the System Setup Mode.
S U
ELECT I N G N I T S
Default = US
Select the units that the monitor will be operating in. Select US units for English measurement
units or select SI units for metric measurement units.
P
Depress the key to accept the flow meter value and advance to the next program step.
RO
S S
PEED ENSOR
Default = 250 pulses/300 ft (100m)
The speed sensor needs to be calibrated in order to provide the proper speed and area
readings. The value for this step is the number of pulses generated by the speed sensor in
300 ft (100 meters).
TeeJet 814 Sprayer Monitor
>US units
C
ALI BRAT I ON
>250 puls/300 ft
Programming and Operating Manual (V1.00) Page 5 of 15