St a rt
To begin the programming process:
*
Read above for programming tips.
*
Be sure the Master switch is "OFF."
*
Turn console "ON" by pressing the Pro key. When the Control Console is turned on, the
software version will be displayed for approximately 5 seconds.
This information will be needed when calling for service support.
Example : the 814-spray monitor is working in US units and the software version is
V2.00A.
*
After a short time the Console will change to the normal monitor mode.
TeeJet 814 Sprayer Monitor
814 US
0.0 MPH
Programming and Operating Manual (V1.00)
V2.10A
0 GPA
Page 4 of 15