Table of Contents
Advertisement
N orm a l M onit or M ode
I
N T RODU CT I ON
The normal monitor mode is the normal working mode of the Console after power up.
The screen always shows one or two values at the same time (one on the left and/or one on
the right hand side). The displayed value can be recognized by the unit text string displayed
after the value e.g. the speed value is shown in MPH (km/h) units.
The usage of the keys during monitoring is summarized as follows:
*
Pro key is used to power ON
*
Clr & Down key combination is used to power OFF (when not spraying)
*
Up and Down arrow keys are used for scrolling through the list of display information
*
Holding Clr key is used to clear counters Ac, Gal (Ha, l)
In the following, the different monitor displays will be described in more detail. An overview is
given in "Appendix A: Overview of Monitor Displays ".
S
PEED AND APPLICATION
The default display is the speed and application rate display. On the left the current speed is
shown in MPH (km/h) and on the right hand side the current application rate in Ac (l/ha) is
shown. When the Master switch is off, the application rate shown is zero.
Press the Up or Down key to select another display.
APPLICATION RATE AND
In this display the application rate in GPA (l/ha) and the pressure in PSI (bar) is shown. The
pressure is only shown when there is a pressure sensor installed.
Press the Up or Down key to select another display.
F
R
LOW
AT E AN D PRESSU RE
In this display the flow rate in GPM (l/min) and the pressure in PSI (bar) is shown. The
pressure is only shown when there is a pressure sensor installed.
TeeJet 814 Sprayer Monitor
R
AT E
5.0 MPH 100 GPA
P
RESSURE
20 GPA
35.2 GPA
Programming and Operating Manual (V1.00)
30 PSI
Page 10 of 15
Advertisement
Table of Contents
