To Use The Remote Control Unit For Tv Operation - JVC XV-515GD Instructions Manual

To use the remote control unit for TV operation

You can operate your TV from the rem ote control unit.
Setting the remote control signal for operating your TV.
1
Holding dow n TV/VIDEO, enter the m anufacturer code of your TV listed below by using the num eric buttons (0 - 9).
Do not release TV/VIDEO. Keep holding it until the next step is com pleted.
M anufacturer code list
No. M anufacturer
01 JVC
02 PANASONIC
03 SONY
04 SHARP
05 TOSHIBA/ BEIJING/ CHANGHONG
06 M ITSUBISHI/ CHANGHONG
07 HITACHI
08 SANYO
09 FUNAI
10 AIWA
11 DAEWOO
12 SAM SUNG
13 LG (GOLDSTAR)
14 THOM SON
15 FERGUSON
16 PHILIPS/ TCL/ CHANGHONG
17 GRUNDIG
2
Press STOP w hile holding dow n TV/VIDEO.
The follow ing buttons can be used for operating the TV:
Turns the TV on or off.
TV
/
+
Changes the TV channels.
TV ch
–
+
Adjusts the TV volum e.
TV VOL.
–
Selects the TV channels
(w hile holding dow n the SHIFT button).
to
0 9 * For som e TVs, pressing "+10" w hile holding dow n SHIFT
functions as the "RETURN," and pressing "10" w hile holding
dow n SHIFT functions as the "– / – –" button.
TV/VIDEO
Sw itches input m ode (either TV or VIDEO).
3
Try to operate your TV by pressing TV
If your TV turns on or off, you have successfully set the control signal.
NOTE
• The remote control unit is initially set for operating a JVC TV.
• If there is more than one code listed for the manufacturer of your TV, try them one by one until you succeed.
No. M anufacturer
18 JTT
19 M IVER
20 FINLUX
21 NOKIA
22 NEC
23 JINXING/ PEONY
24 PEONY
25 PEONY/ CHANGHONG
26 KONKA
27 PEIJIN/ NOBLEX
28 TCL
Example:
To enter the m anufacturer code "01":
Press "0" then "1."
.
Getting started
16