Planet Networking & Communication ISW-504PT User Manual page 5

3. DIP Switch
The Industrial PoE+ Switch provides one DIP switch for Standard, VLAN
and Extended mode selections. The detailed descriptions are shown in the
following table.
DIP Switch Mode
Standard
VLAN
Extend
Switches 1 to 5 are off
This mode makes the Industrial PoE+ Switch operate as
a general switch and all PoE ports operate at 10/100Mbps
auto-negotiation.
Switch 5 is on
This mode makes the Industrial PoE+ Switch operate as a
VLAN isolation switch and
1. Port 1 to 4 will isolate respectively.
2. Port 1 to 4 can only communicate with port 5.
After adjusting VLAN DIP switch, reboot
the Industrial PoE+ Switch to make the
change take effect.
Any of switches 1 to 4 is on
This mode makes the Industrial PoE+ Switch operate on
a per-port basis at 10Mbps full duplex operation but can
support IEEE 802.3af PoE power output over a distance of
up to 250 meters overcoming the 100m limit on Ethernet
UTP cable.
Function
5