Advertisement
01.
All inserts are indicated by the circular white stickers, as shown above. Locate the
inserts through the fabric in the holes indicated above and pierce using a sharp pointed tool
such as a bradawl or the end of a screwdriver, in preparation for passing bolts into
inserts.
Alternatively, carefully make a small cross cut (approx 10mm across) using a sharpe knife
over each of the indicated holes.
03.
A
Q
R
Fix the sides of the seat base box (A) to the ZigZag shell using 4x M6 x 45mm
machine screws (Q) and 4x 30mm washers (R) in the holes marked above. Passing
the bolts (Q) through the washers (R) and holes in the side of the base box (A) into the
inserts in the Den panels.
DEN Seat Assembly Instructions
02.
A
Panel
A
20mm
Levellers
Before assembling, make sure that all the levellers are set so that the bottom of the
base box (A) is flush with the bottom of the Den panels (nominally 20mm from the
ground).
04.
A
P
R
Continue to fix the sides of the seat base box (A) to the ZigZag shell using 2x M6 x
85mm machine screws (P) and 2x 30mm washers (R) in the holes marked above.
Passing the bolts (P) through the washers (R) and holes in the side of the base box (A)
into the inserts in the Den panels.
A - Seat | Base Box
DWG No: SASS-0079
Revision: A (08/12/15)
Drawn by: CE
Drawn date: 09/10/15
Advertisement
