Table of Contents
Advertisement
Massimo
Solo
User interface
Piccolo
3.11
Ethernet Configuration
In Ethernet configuration:
► Solo mode: you can set the IP address of the screen for
connecting through Modbus TCP
►Piccolo mode: Select "Piccolo IP config", in next page
select boiler number. Power cycle after selection
►Massimo mode: Select "Massimo IP config", in next page
select boiler number. Power cycle after selection
3.12
Comms Config
If a Riello gateway is connected to the Riello burner, it is
configured in "BMS communication". The S3 dip switch has
to be in the off position
Available gateway protocols:
► BACnet MS/TP
► BACnet/IP
► Modbus TCP (gateway only needed for Piccolo)
► Ethernet/IP
► Metasys N2
► Lonworks
18
0214190 - 01/2022
Advertisement
Table of Contents
