How To Turn The Power On And Off - Furuno DS-60 Operator's Manual

1. INTRODUCTION
1.2

How to Turn the Power On and Off

Press the PWR key to turn on the power.
The main display unit shows the serial numbers, program numbers and results of the
RAM and ROM checks (OK or NG) for the Display Unit DS-600, Distributor Unit
DS-610, and Transceiver Unit DS-620. The sub display unit shows its serial number,
program number and results of the ROM and RAM check, "OK" or "NG" (No Good).
The table below shows the average time required for each test.
After the program numbers appear and the test results are displayed, "Now calibrat-
ing..." is displayed momentarily on the main display unit, the start-up screen is erased,
then the last-used display appears. This process takes approximately 70 seconds to
complete.
Note: If "NG" appears as the RAM or ROM check result, the equipment stops. Reset
the power to try to restore normal operation. If you cannot restore normal operation,
contact a FURUNO agent or dealer for instruction.
To turn off the power, press the PWR key.
Unit Name
Serial No
Program No
ROM
RAM
Unit Name
Serial No
Program No
ROM
RAM
Unit Name
Serial No
Program No
ROM
RAM
Unit Name
Serial No
Program No
ROM
RAM
Unit Name
Serial No
Program No
ROM
RAM
Unit Name
Serial No
Program No
ROM
RAM
Note: The screen refreshes slower in low ambient temperature.
1-4
Unit Average time required
DS-610 20 seconds
DS-620 25 seconds
Main display unit
: DS-600
: -XXXX
: 6652002-xx.xx
: OK
: OK
: DS-610
: XXXX-XXXX
: 6652102-xx.xx
: OK
: OK
: DS-620
: XXXX-XXXX
: 6652202-xx.xx
: OK
: OK
: DS-600
: -XXXX
: 6652002-xx.xx
: OK
: OK
: DS-610
: XXXX-XXXX
: 6652102-xx.xx
: OK
: OK
: DS-620
: XXXX-XXXX
: 6652202-xx.xx
: OK
: OK
Now calibrating...
Sub display unit
Unit Name : DS-600
Serial No : -XXXX
Program No : 6652002-xx.xx
ROM : OK
RAM : OK