Table of Contents
Advertisement
4.5 Attaching Power Cable Connector NCS-253P
Solder lead wire to armor and
connect it to #1 pin of connector.
Figure 4-8 Attachment of power supply cable connector
4.6 Synchronizing Transmission with Other Sonars,
Echo Sounders
To synchronize the transmission of the CSH-53 with that of other sonars or echo sounders, do
the following.
Wiring
a) For current driven KP
DISPLAY UNIT
EXT KP H < Z
EXT KP C < AA
Note: To output KP to other sonar or echo sounder, do the following:
a) For current driven KP
DISPLAY UNIT
EXT KP H < DD
EXT KP C < EE
Figure 4-9 Connections for synchronizing transmission with other sonars, echo sounders
Menu Setting
Set polarity of the KP on the INIT SET/TEST menu. Refer to the operator's manual for opera-
tion on the menu.
Armor
#2
#3
#1
CN-A6
E/S
Sonar
CN-A6
E/S
Sonar
Cable DPYCY-1.25
Vinyl sheath
Taping
Use cable DPYCY-1.25
(Japan standard cable)
or equivalent cable.
b) For voltage driven KP
DISPLAY UNIT
EXT KP < MM
GND < TT
b) For voltage driven KP
DISPLAY UNIT
INT KP < KK
GND < RR
17
Armor
Vinyl
sheath
Conductor
2
S = 1.25 mm
∅
= 1.35 mm
CN-A6
E/S
Sonar
E/S
Sonar
Advertisement
Table of Contents
