Program Transmitter To Operate - Merlin Commander Essential my Q capable MS65MYQ Installation And Operating Instructions Manual

PROGRAM TRANSMITERS TO THE OPENER LIGHT
21
To Program your transmitters to operate your garage door opener
light follow the below steps:
1. Press and release the "LEARN" button, and the "courtesy
light" will flash twice (fig.1).
2. Press and release the "PROG" button and the garage door
opener will go into courtesy light learn mode for 30 seconds
(fig.2).
3. Press any transmitter button (fig.3) to learn this button to the
garage door opener courtesy light, the garage door opener
"courtesy light" will flash twice.
NOTE: Do not use the same transmitter button that has been
previously learned to the garage door opener for operation.
The transmitter is now learnt to the garage door opener courtesy
light.
To Erase all Transmitter Codes
1. Press and hold the "LEARN" button on the opener until the
courtesy light flashes twice, and continue holding for
approximately 8 seconds, until the courtesy light flashes twice
again.
2. Release the button, all codes are now erased.
ADJUSTABLE COURTESY LIGHT TIME CHANGE
22
This feature will allow you to adjust the garage door opener light "ON" time as desired.
The courtesy light "ON" time is factory default set to 3 minutes.
NOTE: Every time you enter into program mode the unit will start at the default
time of 3 minutes.
1. Press and release the "LEARN" button (fig.1), and the indicator LED will turn on
solid.
2. Press and release the "PROG" button twice (fig. 2). The courtesy light will flash
once. The garage door opener is now in courtesy light "time selection mode" for
30 seconds*.
3. Press the "UP" arrow button (fig. 3) to increase the courtesy light "ON" time:
- 1 press of the "UP" arrow button will change the courtesy light "ON" to 5 minutes.
- 2 presses of the "UP" arrow button will change the courtesy light "ON" time to 10
minutes.
4. Press the "DOWN" arrow button (fig.4) to decrease the courtesy light "ON" time:
- 1 press of the "DOWN" arrow button will change the courtesy light "ON" to 1.5
minutes.
- 2 presses of the "DOWN" arrow button will change the courtesy light "ON" time
to 30 seconds.
NOTE: The courtesy light will flash once each time the "UP" or "DOWN" arrow
button is pressed.
5. Press "PROG" button (fig.5) on the opener to save the settings. The courtesy light
flashes twice.
* NOTE: If after 30 seconds no button is pressed, the garage door opener will
exit from program mode and the courtesy light will flash 5 times. No settings will
have been saved.
PROGRAMMING
14
fig.1
Indicator LED
fig.2
Indicator LED
fig.3
or
fig.1
Indicator LED
fig.2
Indicator LED
fig.3
Indicator LED
fig.4
Indicator LED
fig.5
Indicator LED