Timer Recording; G- Code ™/Show View ™ System Setup - JVC G-code ShowView HR-S5900AM Instructions Manual

26
EN
G- / S
™
CODE
System Setup
Turn on the TV and select the VIDEO channel (or AV mode).
IN FO RM ATIO N
G- and S V
CODE HOW IEW
represent the same easy recording feature, but only the term
G- system will be used in the instructions. If you use the
CODE
S V system, follow the same instructions listed for
HOW IEW
the G- system.
CODE
MENU
V
HOW IEW
are different trademarks used to
NUMBER
OK
PUSH JOG
The G- timer programming system eliminates the need to
CODE
input channel, date, start and stop time data when setting the
timer record function. Simply key in the G-
™
TV programme you wish to record (found in most TV listings)
and the recorder's timer is automatically programmed.
You have to set "GUIDE PROG" numbers, which are assigned to
each station for purposes of G-
stations stored in your recorder's memory to get proper results.
Before G-
CODE
following procedures:
● Tuner setting (
● Clock setting (
IM PO RTAN T
Perform the following procedure after Auto Set Up on page 8
and/or the channel setting steps on pages 54– 57.
After setting the Guide Program Numbers, channel positions
may be incorrect if you stored or skipped channels. In this case,
re-perform Guide Program Number setting.
Guide Progra m N umber Set
ACCESS MAIN MEN U
SCREEN
1
Press MENU.
ACCESS IN ITIAL SET
SCREEN
2
Press PUSH JOG %fi to place the pointer next to
"INITIAL SET", then press OK or PUSH JOG
ACCESS G-CO DE/
SHO W VIEW SETUP
SCREEN
3
Press PUSH JOG %fi to place the pointer next to
"G-CODE/SHOWVIEW SETUP", then press OK or
PUSH JOG
EN TER GUIDE PRO G
N UMBER
4
Press PUSH JOG %fi or
NUMBER keys to enter the
Guide Program number for
the desired station as shown
in the TV listings. Then press
OK or PUSH JOG

TIMER RECORDING

timer programming, for all the
CODE
system setup you must have performed the
pg. 8, 54)
pg. 12)
# .
G-CODE/SHOWVIEW SETUP
GUIDE PROG
.
#
[0-9] OR [5/ ∞ ]:SELECT =
[MENU] : EXIT
number for the
CODE
# .
TV PROG
2 5