Setting Up The Uwl-1; Connecting The Transmitter (Utx-1) - Onkyo UWL-1 Instruction Manual

Setting Up the UWL-1

Connecting the Transmitter (UTX-1)

1
Start up your PC.
Wait until the startup process is complete and Windows
Note: Before you plug or unplug the Transmitter, turn down the volume on your audio sys-
tem or powered speakers, or unplug the Receiver's AC adapter from the wall outlet.
2
Remove the Transmitter's cap, and then plug the
Transmitter into a USB port on your PC.
The Transmitter's Transmit indicator lights up.
Be careful to insert the Transmitter the right way.
When you plug the Transmitter into your PC for the very
first time, Windows
hardware and install the necessary drivers. Please wait
until this process is complete. If Windows
it automatically, see below.
Notes:
• Since the Transmitter requires a lot of power, it should be connected directly to a USB port
on your PC. However, if your PC is located on the floor, or it's a large tower or desktop PC
and its USB ports are located at the rear, wireless transmission may be obstructed and audio
playback may be interrupted. In this case, try moving the Transmitter to another location. If
you can't relocate your PC, using a commercially available USB extension cable and mov-
ing the Transmitter to another location may resolve the issue. If you're using a powered USB
hub, make sure its AC adapter is plugged in when you use the UWL-1.
• Always stop audio playback on your PC before plugging in or unplugging the Transmit-
ter. It's OK to plug in or unplug the Transmitter while your PC is on.
• If your PC has several USB ports, you can plug the Transmitter into any port. Note that
some PCs may detect the Transmitter as a new device if you plug it into another port. In
this case, simply allow Windows
• Always plug the Transmitter into your PC before starting playback. If you plug it in after
starting playback, the audio will not be transmitted.
• While the Transmitter is plugged into your PC, your PC's built-in speakers will not output
any sound. This is because USB audio devices have priority. To output sound from your
PC's built-in speakers, unplug the Transmitter, or change the Default device setting on the
Audio tab of the Sounds and Audio Devices Properties control panel (see page 19).
®
If Windows doesn't install the drivers automatically, unplug the Transmitter, wait about 15 sec-
onds, then plug it in again. If it still doesn't install them, follow the procedure below:
1.
Click the Start button, and then click Control Panel.
2.
Click Performance and Maintenance, and then click System.
3.
Select the Hardware tab, and then click the Device Manager button.
4.
Double-click the corresponding item in the device list to open the Properties window.
5.
Select the Driver tab, click the Update Driver button to open the Add Hardware Wizard, and
follow the onscreen instructions to install the drivers.
®
will automatically detect it as new
®
to perform the installation again.
®
is ready to use.
(The position and number of USB
®
does not detect
ports depends on your PC. Check
your PC's manual for details.)
Transmit indicator
9