Confirming The Audio Playback Device - Onkyo UWL-1 Instruction Manual

Troubleshooting—Continued
Confirming the Audio Playback Device
You can confirm that the correct audio playback is selected.
■ Windows
®
XP
Click the Start button, click Control Panel, click Sounds, Speech, and Audio Devices,
click Sounds and Audio Devices, and then click the Audio tab.
■ Windows
®
2000
Click the Start button, point to Settings, click Control Panel, click Sounds and Multime-
dia, and then click the Audio tab.
To use the UWL-1, in the Sound playback section, the Default device should be set to:
• C-Media USB Headphone Set
Normally, this is selected automatically when the Transmitter is plugged into your PC.
Notes:
• Depending on your operating system, Sound playback may be labelled Playback,
Default service may be Preferred device, and C-Media USB Headphone Set may be
USB audio device.
• If you open the Audio tab immediately after plugging in the Transmitter, C-Media USB
Headphone Set may not appear as the Default device. So when you plug in the Trans-
mitter, wait a while before opening the Audio tab. Before you unplug the Transmitter and
plug it in again, close the Audio tab first.
• To temporarily turn off audio transmission by the UWL-1 and output sound from your
PC's built-in speakers, in the Sound playback section, select the Default device that's
used when the Transmitter is not plugged into your PC. To use the UWL-1 again, select
C-Media USB Headphone Set.
Select: C-Media USB Headphone Set
19