Frequency Step Setting - Onkyo TX-NR686 Instruction Manual

When FM broadcasts reception is poor:
Manually" ( p61). Note that if you tune manually, the reception for FM
broadcasts will be monaural rather than stereo, irrespective of the sensitivity of
the reception.
Tuning Manually
Note that if you tune manually, the reception for FM broadcasts will be monaural
rather than stereo, irrespective of the sensitivity of the reception.
1. Press TUNER repeatedly to select either "AM" or "FM".
2. Press MODE to display "TunMode: Manual" on the display.
3. While pressing the cursors / , select the desired radio station.
• Each time you press the cursors
If the button is held down, the frequency changes continuously, and if the
button is released, the frequency stops changing.

Frequency step setting

Press , and using the cursors and ENTER, select "7. Miscellaneous" - "Tuner" -
"AM/FM Frequency Step" or "AM Frequency Step", and then select the frequency
step for your area. For Taiwanese models, the default value is "10 kHz / 0.2 MHz"
at the time of purchase. Please change it to "9 kHz / 0.05 MHz". Note that when
this setting is changed, all radio presets are deleted.
Contents
Perform the procedure for "Tuning
/ , the frequency changes by 1 step.
Connections
≫
❏ Presetting a Radio Station (
61
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
p62)
≫